Fanuc Power Mate i-D/H Operator Manual

2. FUNCTION TO SIMPLIFY
PROGRAMMING
PROGRAMMING
(For the Power Mate i–D/D2)
B–63174EN/03
209
Before the drilling axis can be changed, the canned cycle must be
canceled. If the drilling axis is changed in rigid mode, alarm (No.206) is
issued.
Specifying a rotation speed exceeding the maximum speed for the gear
used causes alarm (No.200).
Specifying a value that exceeds the upper limit of cutting feedrate causes
alarm (No.011).
Specifying an S command or axis movement between M29 and G84
causes alarm (No.203).
Then, specifying M29 in the tapping cycle causes alarm (No.204).
Specify R in a block that performs drilling. If R is specified in a
non–drilling block, it is not stored as modal data.
Do not specify a group 01 G code (G00 to G03) and G74 in the same block.
If they are specified together, G74 is canceled.
Z–axis feedrate 1000 mm/min
Spindle speed 1000 min
–1
Thread lead 1.0 mm
G00 X120.0 ; Positioning
M29 S1000 ; Rigid mode specification
G74 Z–100.0 R–20.0 F1000 ; Rigid tapping
Limitations
Axis switching
S command
F command
M29
R
Cancel
Examples

Leave a Reply

Your email address will not be published. Required fields are marked *