Fanuc Power Mate i-D/H Operator Manual

2. FUNCTION TO SIMPLIFY
PROGRAMMING
PROGRAMMING
(For the Power Mate i–D/D2)
B–63174EN/03
213
CAUTION
The machining axis of the rigid threading cycle for a chaser
tool is the first axis only. When bit 0 (FXY) of parameter No.
5101 is set to 1, a plane must be selected with G19.
The rigid tapping canned cycle is canceled. For how to cancel this cycle,
see Section 2.1.13.
2.2.5
Canned Cycle Cancel
(G80)

Leave a Reply

Your email address will not be published. Required fields are marked *