Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Power Mate i–H)
1. ELECTRONIC CAM FUNCTION
B–63174EN/03
220
NOTE
1 Before performing electronic cam operation, perform phase
matching for a tracing axis to be engaged in electronic cam
operation. If electronic cam operation is performed when
the phase matching completion signal ECMCP* (F223) for
a tracing axis to be engaged in electronic cam operation is
not set to 1, alarm No. 5249 is issued.
2 Cutting feed acceleration/deceleration (exponential, linear,
or bell–shaped) can be applied to a tracing axis during
electronic cam operation. However, do not perform this
operation because a cam figure error occurs.
3 When a complicated cam figure as shown below is used,
tracing may be disabled due to servo delay or for some other
reason, depending on the speed of the cam shaft.
4 Electronic cam operation can also be performed with an
input signal.
Created cam figure
Electronic cam
operation
Cam figure after
electronic cam operation

Leave a Reply

Your email address will not be published. Required fields are marked *