Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Power Mate i–H)
B–63174EN/03
2. MULTIPATH CONTROL
229
There are three types of wait functions.
(1) Inter–path wait
This type of wait is used by one path to wait for another within the
same Power Mate i–H.
(2) Wait for peripheral equipment
This type of wait is used to wait for peripheral equipment according
to PMC signal conditions.
(1)
(2)
CNC section
Path 1 Path 2
PMC section
Peripheral equipment
Power Mate i–H
2.2.1
Types of Wait Functions

Leave a Reply

Your email address will not be published. Required fields are marked *