Fanuc Power Mate i-D/H Operator Manual

3. HIGH–SPEED RESPONSE
FUNCTION
PROGRAMMING
(Power Mate i–H)
B–63174EN/03
245
Number Contents
1001 Both group 00 G code and group 01 G code were specified in the
same block.
1002 The number of words for a block was over the maximum.
1010 In the block including the command G31, no axis movement
command is specified, or two or more axes movement commands
are specified.
1011 An unusable P code is specified in the block including the
command G31
The macro variable after P in the G31 block is specified.
Example) G90 G31 P#1000000 X0 ;
1020 G code is specified in the block including the M code.
1021 The axis movement command is specified in the block including
the M code.
1022 An unusable M code is specified.
1024 An unusable P code is specified in the block including the M code.
This error occurs when one of the following commands is
specified.
The macro variable ’#’ is specified for M code group number.
Example) M50 P#1000000 ;
The macro variable ’#’ is specified for the parameter of the M
code output function.
Example) M40 P#1000000 Q1 ;
1025 P code is not specified in the block including the M code.
1027 The feed rate F is specified in the block including the M code.
1030 The macro sentence is not available because of the parameter
setting.
1040 In the block including the command of the continuous feed
(G135.1), no axis movement command is specified, or two or more
axes movement commands are specified
1060 The operator for the arithmetic or logic operation (=) is not correct.
Example) #1000000 = #1000000 ABS[#1200000] ;
1061 The number of the sequence number in a program is 1001 or over.
1062 The number of terms in the right of the operator is 2 or over.
Example) #1000000 = #1200000 + #1200000+ #1200000 ;

Leave a Reply

Your email address will not be published. Required fields are marked *