Fanuc Power Mate i-D/H Operator Manual

3. HIGH–SPEED RESPONSE
FUNCTION
PROGRAMMING
(Power Mate i–H)
B–63174EN/03
254
Absolute command G90 _ ;
Incremental command G91 _ ;
IP
IP
Two methods of travel distance specification are available: absolute
command and incremental command.
The absolute command programs the coordinates of an end point.
The incremental command directly programs a travel distance.
G92 _ ;IP
With G92, a workpiece coordinate system is set so that the point where
the tool is placed, for example, the machine tip, is at specified coordinates.
G135.1 _ F_ ;IP
By setting the signal +Jn/–Jn to 1 during execution of a G135.1 block, the
tool can be continuously moved on a selected axis in a selected direction.
By setting the signal +Jn/–Jn to 0 during movement, the tool can be
gradually stopped on a specified axis. If an absolute command is used,
the tool stops at a specified coordinate. If an incremental command is
used, the tool stops at a position reached by moving by a distance equal
to a specified value after the signal is set to 0. After a gradual stop, the
block following the G135.1 block is executed.
With this function, the tool can be moved in a selected direction
continuously as in the case of manual continuous feed in the normal mode.
3.1.6
G90, G91 (Absolute
Command and
Incremental Command)
Format
Explanations
3.1.7
G92 (Workpiece
Coordinate System
Setting)
Format
Explanations
3.1.8
G135.1 (Continuous
Feed)
Format
Explanations

Leave a Reply

Your email address will not be published. Required fields are marked *