Fanuc Power Mate i-D/H Operator Manual

1. GENERAL
B–63174EN/03
OPERATION
302
When the cycle start pushbutton is pressed, the tool executes one
operation then stops. By pressing the cycle start again, the tool executes
the next operation then stops. The program is checked in this manner.
Cycle start
Cycle start
Cycle start
Cycle start
Stop
Stop
Stop
Tool
Workpiece
Fig.1.4.1 (c) Single Block
Tool
CRT/MDI
X
Y
Change cause by machine
movement
The tool remains stopped, and only the
positional displays of the axes change.
Workpiece
Fig.1.4.2 Machine Lock
When automatic running is placed into the auxiliary function lock mode
during the machine lock mode, all auxiliary functions (spindle rotation,
tool replacement, coolant on/off, etc.) are disabled.
Single block
(See Section V–5.5)
1.4.2
How to View the
Position Display
Change without
Running the Machine
Explanations
Machine lock
(See Sections V–5.1)
Auxiliary function lock
(See Section V–5.1)

Leave a Reply

Your email address will not be published. Required fields are marked *