Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
1. GENERAL
OPERATION
303
After a created program is once registered in memory, it can be corrected
or modified from the CRT/MDI panel (See Section V–9).
This operation can be executed using the part program storage/edit
function.
Program registration
CRT/MDI
CNC CNC
Program correction or modification
Tape reader
CNC tape (program)
Fig.1.5 Part Program Editing
1.5
EDITING A PART
PROGRAM

Leave a Reply

Your email address will not be published. Required fields are marked *