Fanuc Power Mate i-D/H Operator Manual

1. GENERAL
B–63174EN/03
OPERATION
304
The operator can display or change a value stored in CNC internal
memory by key operation on the screen (See V–11).
Data setting
CRT/MDI
Data display
Screen Keys
CNC memory
Fig.1.6 (a) Displaying and Setting Data
Tool compensation number1
12.3
Tool compensation number2
20.0
Tool compensation number3
⋅⋅⋅
⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅⋅ ⋅⋅⋅
Setting
Display
CNC memory
Screen Keys
CRT/MDI
Fig.1.6 (b) Displaying and Setting Offset Values
Machining requires the use of a tool.
The tool has the tool dimension (length). When a workpiece is machined,
the tool movement route depends on the tool dimensions.
By setting tool dimension data in CNC memory beforehand,
automatically generates tool routes that permit any tool to cut the
workpiece specified by the program. Tool dimension data is called the
offset value (See Section V–11.4.1).
1.6
DISPLAYING AND
SETTING DATA
Explanations
Offset value

Leave a Reply

Your email address will not be published. Required fields are marked *