Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
1. GENERAL
OPERATION
305
Apart from parameters, there is data that is set by the operator in
operation. This data causes machine characteristics to change.
For example, the following data can be set:
Inch/Metric switching
Data related to I/O devices
Mirror image operation on/off
The above data is called setting data (See Section V–11.4.3).
Setting
DisplayingScreen Keys
Setting data
Inch/Metric switching
I/O device data
Mirror image operation ON/
OFF setting
Controller Memory
Program
Automatic
operation
Operational
characteristics
Movement of
the machine
Fig.1.6 (c) Displaying and Setting Operator’s setting data
Displaying and setting
operator’s setting data

Leave a Reply

Your email address will not be published. Required fields are marked *