Fanuc Power Mate i-D/H Operator Manual

1. GENERAL
B–63174EN/03
OPERATION
310
Programs, offset values, parameters, etc. Input in CNC memory can be
output to paper tape, cassette, or a floppy disk for saving. After once
output to a medium, the data can be input into controller memory.
Memory
Program
Offset
Parameters
Reader/puncher
interface
Controller
FANUC Floppy Cassette
Floppy disk
Floppy
Cassette
.
.
.
Floppy disk
Handy File
FANUC Handy File
Fig.1.8 Data Input/Output
1.8
DATA INPUT/OUTPUT

Leave a Reply

Your email address will not be published. Required fields are marked *