Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
1. GENERAL
B–63174EN/03
16
Y
Y
Table
Workpiece
X
X
Coordinate system specified
by the NC established on the
table
Coordinate system on
drawing established on
the workpiece
Fig.1.3.2 (c) Coordinate system specified by CNC and coordinate system
on drawing
The tool moves on the coordinate system specified by the NC in
accordance with the command program generated with respect to the
coordinate system on the drawing, and cuts a workpiece into a shape on
the drawing.
Therefore, in order to correctly cut the workpiece as specified on the
drawing, the two coordinate systems must be set at the same position.

Leave a Reply

Your email address will not be published. Required fields are marked *