Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
B–63174EN/03
1. GENERAL
17
To set the two coordinate systems at the same position, simple methods
shall be used according to workpiece shape, the number of machinings.
(1) Using a standard plane and point of the workpiece.
Program
zero point
Y
X
Workpiece’s
standard point
Fixed distance
Bring the tool center to the workpiece standard point.
And set the coordinate system specified by CNC at this position.
Fixed distance
(2) Mounting a workpiece directly against the jig
Jig
Program zero point
Meet the tool center to the reference position. And set the coordinate
system specified by CNC at this position. (Jig shall be mounted on the
predetermined point from the reference position.)
(3) Mounting a workpiece on a pallet, then mounting the workpiece and
pallet on the jig
Pallet
(Jig and coordinate system shall be specified by the same as (2)).
Jig
Workpiece
Methods of setting the
two coordinate systems
in the same position

Leave a Reply

Your email address will not be published. Required fields are marked *