Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
2. OPERATIONAL DEVICES
OPERATION
337
After a character or number has been input from the MDI panel, a data
check is executed when
INPUT
key or a soft key is pressed. In the case of
incorrect input data or the wrong operation a flashing warning message
will be displayed on the status display line.
Warning message display
Data input display
Soft key display
Status display
[ ] [ ] [ ] [ ] [ ]
EDIT WRONG MODE
> _
Fig.2.2.5 Warning message display
Table 2.2.5 Warning Messages
Warning message Content
FORMAT ERROR The format is incorrect.
WRITE PROTECT Key input is invalid because of memory protect sig-
nal or the parameter is not write enabled.
DATA IS OUT OF RANGE The input value exceeds the permitted range.
TOO MANY DIGITS The input value exceeds the permitted number of
digits.
WRONG MODE Parameter input is not possible in any mode other
than MDI mode.
EDIT REJECTED It is not possible to edit in the current CNC status.
2.2.5
Warning Messages

Leave a Reply

Your email address will not be published. Required fields are marked *