Fanuc Power Mate i-D/H Operator Manual

2. OPERATIONAL DEVICES
B–63174EN/03
OPERATION
340
The Handy File is an easy–to–use, multi function floppy disk
input/output device designed for FA equipment. By operating the Handy
File directly or remotely from a unit connected to the Handy File,
programs can be transferred and edited.
The Handy File uses 3.5–inch floppy disks, which do not have the
problems of paper tape (i.e., noisy during input/output, easily broken, and
bulky).
One or more programs (up to 1.44M bytes, which is equivalent to the
memory capacity of 3600–m paper tape) can be stored on one floppy disk.
RS–232–C
(Punch panel, etc.)
FANUC
Handy File
RS–232–C
Interface
When the Floppy Cassette is connected to the NC, machining programs
stored in the NC can be saved on a Floppy Cassette, and machining
programs saved in the Floppy Cassette can be transferred to the NC.
RS–232–C Interface
(Punch panel, etc.)
FANUC
ON
OFF
POWER
2.3.1
FANUC Handy File
2.3.2
FANUC Floppy
Cassette

Leave a Reply

Your email address will not be published. Required fields are marked *