Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
2. OPERATIONAL DEVICES
OPERATION
341
Procedure of Turning on the Power
1 Check that the appearance of the CNC machine tool is normal.
(For example, check that front door and rear door are closed.)
2 Turn on the power according to the manual issued by the machine tool
builder.
3 After the power is turned on, check that the position screen is
displayed. If the screen shown in V–2.4.2 is displayed, a system
failure may have occurred.
AUTO STRT MTN *** 09:06:35
ACTUAL POSITION(WORK) O1000 N00010
PART COUNT 5
RUN TIME 0H15M CYCLE TIME 0H 0M38S
ACT.F 3000 MM/M
X 123.456
Y 363.233
[][][][][]WORK REL ALL HNDL OPRT
4 Check that the fan motor is rotating.
WARNING
When pressing the <POWER ON> key, do not touch any
other CRT/MDI panel keys. Until the positional or alarm
screen is displayed, do not touch them. Some keys are
used for the maintenance or special operation purpose.
When they are pressed, unexpected operation may be
caused.
2.4
POWER ON/OFF
2.4.1
Turning on the Power
Procedure

Leave a Reply

Your email address will not be published. Required fields are marked *