Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
2. OPERATIONAL DEVICES
OPERATION
343
1 Check that the LED indicating the cycle start is off on the operators
panel.
2 Check that all movable parts of the machine is stopping.
3 If an external input/output device such as the Handy File is connected
to the contoroller, turn off the external input/output device.
4 Continue to press the POWER OFF pushbutton for about 5 seconds.
5 Refer to the machine tool builders manual for turning off the power
to the machine.
2.4.3
Power Disconnection
Procedure

Leave a Reply

Your email address will not be published. Required fields are marked *