Fanuc Power Mate i-D/H Operator Manual

4. AUTOMATIC OPERATION
B–63174EN/03
OPERATION
358
For the Power Mate i–D2 a cycle start switch is provided for each tool
post. Thus, only one path can be started and operated independently in
memory operation or MDI operation, or the two paths are started and
operated simultaneously. In general, select the tool post to be operated
with the tool post selection switch on the machine operators panel and
then press the cycle start button to activate the selected tool post. (The
procedure may vary with the machine tool builder. Refer to the
appropriate manual issued by the machine tool builder.)
Cycle start for the
Power Mate i–D2

Leave a Reply

Your email address will not be published. Required fields are marked *