Fanuc Power Mate i-D/H Operator Manual

4. AUTOMATIC OPERATION
B–63174EN/03
OPERATION
360
When the program end (M02, M30) or ER(%) is executed, the prepared
program will be automatically erased and the operation will end. By
command of M99, control returns to the head of the prepared program.
O0001 N00003
MDI
* * * * * * * * * * 12:42:39
PROGRAM (MDI)
G00 X100.0 ;
M03 ;
G01 Z120.0 F500 ;
M98 P9010 ;
G00 Z0.0 ;
%
G00 G90 G94 G80
G17 G22 G21 G49 G67
HM
T
FS
>_
O0000
[][][][][]PRGRM MDI CURRNT NEXT (OPRT)
6 To stop or terminate MDI operation in midway through, follow the
steps below.
a.
Stopping MDI operation
Press the feed hold switch on the machine operators panel. The
feed hold LED goes on and the cycle start LED goes off. The
machine responds as follows:
(i) When the machine was moving, feed operation decelerates
and stops.
(ii) When dwell was being performed, dwell is stopped.
(iii) When M, S, or T was being executed, the operation is
stopped after M, S, or T is finished.
When the cycle start switch on the machine operators
panel is pressed, machine operation restarts.
b. Terminating MDI operation
Press the
RESET
key on the CRT/MDI panel.
Automatic operation is terminated and the reset state is entered.
When a reset is applied during movement, movement decelerates
then stops.
Place the system in MDI mode and select the program screen.
The following screen appears.
> O0000
%
The program number, O0000”, is automatically inserted. Create the
program to be executed according to the same procedure as in normal
program editing.
Resetting the system does not erase the newly created program. To erase
it, perform the operation described in Note 3.
Continuous–state information must be checked with diagnostic data.
Procedure for DPL/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *