Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
4. AUTOMATIC OPERATION
OPERATION
363
By activating automatic operation during the DNC operation mode
(RMT), it is possible to perform DNC operation while a program is being
read in via reader/puncher interface.
To use the DNC operation function, it is necessary to set the parameters
related to the reader/punch interface in advance.
DNC OPERATION
1 Search for the program (file) to be executed.
2 Press the REMOTE switch on the machine operators panel to set
RMT mode, then press the cycle start switch. The selected file is
executed. For details of the use of the REMOTE switch, refer to the
relevant manual supplied by the machine tool builder.
PROGRAM CHECK O0001 N00020
N020 X100.0 Z100.0 (DNC–PROG) ;
N030 X200.0 Z200.0 ;
N050 X400.0 Z400.0 ;
(RELATIVE) (DIST TO GO) G00 G17 G90
X 100.000 X 0.000 G22 G94 G21
Y 100.000 Y 0.000 G41 G49 G80
Z 0.000 Z 0.000 G98 G50 G67
A 0.000 A 0.000
C 0.000 C 0.000 H M
HD.T NX.T M
F S M
ACT.F SACT REPEAT
RMT STRT MTN*** *** 21:20:05
Program check screen
[][][][][]ABS REL (OPRT)
PROGRAM O0001 N00020
N020 X100.0 Z100.0 (DNC–PROG) ;
N030 X200.0 Z200.0 ;
N040 X300.0 Z300.0 ;
N050 X400.0 Z400.0 ;
N060 X500.0 Z500.0 ;
N070 X600.0 Z600.0 ;
N080 X700.0 Z400.0 ;
N090 X800.0 Z400.0 ;
N100 X900.0 Z400.0 ;
N110 X1000.0 Z1000.0 ;
N120 X800.0 Z800.0 ;
RM STRT MTN *** *** 21:20:05
Program screen
[][][][][]PRGRM CHECK (OPRT)
4.3
DNC OPERATION
(UNAVAILABLE TO
THE Power Mate i
–D2)
Procedure

Leave a Reply

Your email address will not be published. Required fields are marked *