Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
4. AUTOMATIC OPERATION
OPERATION
367
During automatic operation, the mirror image function can be used for
movement along an axis. To use this function, set the mirror image switch
to ON on the machine operators panel, or set the mirror image setting to
ON from the CRT/MDI panel.
Y
X
Y–axis mirror image goes on.
Programmed tool path
Tool path after the mirror
image function is used
Tool
Fig.4.5 Mirror Image
The following procedure is given as an example. For actual operation,
refer to the manual supplied by the machine tool builder.
1 Press the single block switch to stop automatic operation. When the
mirror image function is used from the begining of operation, this step
is omitted.
2 Press the mirror image switch for the target axis on the machine
operators panel.
Alternatively, turn on the mirror image setting by following the steps
below:
2–1 Set the MDI mode.
2–2 Press the
OFFSET
SETTING
function key.
2–3 Press the
[SETING] soft key for chapter selection to display the
setting screen.
SETTING (MIRROR IMAGE) O0020 N00001
AUTO
* * * * * * * * * *
MIRROR IMAGE X = (0 : OFF 1 : ON)
MIRROR IMAGE Y = 0 (0 : OFF 1 : ON)
>_
1
14:47:57
[][][][][]OFFSET SETING (OPRT)
2–4 Move the cursor to the mirror image setting position, then set the
target axis to 1.
3 Enter an automatic operation mode (AUTO mode, MDI mode or RMT
mode), then press the cycle start button to start automatic operation.
4.5
MIRROR IMAGE
Procedure

Leave a Reply

Your email address will not be published. Required fields are marked *