Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
6. SAFETY FUNCTIONS
OPERATION
379
Bit 7 (BFA) parameter of No.1300 selects whether an alarm is displayed
immediately before the tool enters the forbidden area or immediately after
the tool has entered the forbidden area.
Set the forbidden area per posts for the Power Mate i–D2.
Number Message Contents
500 OVER TRAVEL:
+n
The n–th axis (1–8) exceeded + side stored
stroke check.
501 OVER TRAVEL:
–n
The n–th axis (1–8) exceededside stored
stroke check.
Timing for displaying
an alarm
Setting the forbidden
area of the Power Mate i
–D2
Alarms

Leave a Reply

Your email address will not be published. Required fields are marked *