Fanuc Power Mate i-D/H Operator Manual

7. ALARM AND SELF–DIAGNOSIS
FUNCTIONS
B–63174EN/03
OPERATION
381
When an alarm occurs, the alarm screen appears.
ALARM MESSAGE
MDI
* * * *
* * * * * *
O0000 N00000
100 PARAMETER WRITE ENABLE
500 OVER TRAVEL :+X
500 OVER TRAVEL :+Y
501 OVER TRAVEL :–X
18:52:05
S 0 T0000
[][][][][]ALARM MSG HISTRY
ALM
In some cases, the alarm screen does not appear, but an ALM is displayed
at the bottom of the screen.
ALM
PARAMETER (RS232C INTERFACE) O1000 N00010
AUTO
* * * *
* * * * * *
0100 ENS NCR CTV
00000000
0101 NFD ASI SB2
00000001
0102 DEVICE NUM. (CH0) 2
0103 BAUDRATE (CH0) 10
0111 NFD ASI SB2
00000000
0112 DEVICE NUM. (CH1) 0
0113 BAUDRATE (CH1) 0
)_
08:41:27
[][][][][]
NO.SRH ON:1 OFF:0 +INPUT INPUT
In this case, display the alarm screen as follows:
1 Press the function key
MESSAGE
.
2 Press the chapter selection soft key [ALARM].
7.1
ALARM DISPLAY
Explanations
Alarm screen (CRT/MDI)
Another method for
alarm displays (CRT/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *