Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
B–63174EN/03
1. GENERAL
23
The block and the program have the following configurations.
NĂĂGĂĂĂX.ĂY.ĂĂĂMĂĂĂSĂĂĂT ;
1 block
Sequence
number
Preparatory
function
Dimension word Auxiliary
function
Spindle
function
(Power
Mate i
D/D2)
Tool
func-
tion
End of
block
Fig.1.7 (b) Block configuration
Each block contains a sequence number for distinguishing the block
sequence at the beginning of the block, and an end–of–block code for
indicating the end of the block.
This manual indicates the end–of–block code by ; (LF in the ISO code and
CR in the EIA code).
;
O;
M30 ;
Program number
Block
Block
Block
End of program
Fig.1.7 (c) Program configuration
Normally, a program number is specified after the end–of–block (;) code
at the beginning of the program, and a program end code (M02 or M30)
is specified at the end of the program.
Explanations
Block
Program

Leave a Reply

Your email address will not be published. Required fields are marked *