Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
393
When the program is input from the floppy, the file to be input first must
be searched.
For this purpose, proceed as follows:
File 1
File searching of the file n
File n
BlankFile 2 File 3
File heading
1 Press the EDIT or AUTO switch on the machine operators panel.
2 Press function key
PROG
, then the program contents display screen or
program check screen appears.
3 Press soft key [(OPRT)]
4 Press the rightmost soft key (next–menu key).
5 Enter address N.
6 Enter the number of the file to search for.
N0
The beginning of the cassette is searched.
One of N1 to N9999
Of the file Nos. 1 to 9999, a designated file is searched.
N–9999
The file next to that accessed just before is searched.
N–9998
When N–9998 is designated, N–9999 is automatically inserted
each time a file is input or output. This condition is reset by the
designation of N0, N1 to 9999, or N9999 or reset.
7 Press soft keys [FSRH] and [EXEC]
The specified file is searched for.
1 Select EDIT or AUTO mode.
2 Push
PRGRM
key to select the program screen.
3 Key in address N.
4 Key in a file number.
5 Press
READ
key.
The following head searching occurs according to the number specified:
(a) N0
The beginning of the cassette is searched.
(b) One of N1 to N9999
Of the file Nos. 1 to 9999, a designated file is searched.
(c) N–9999
The file next to that accessed just before is searched.
8.2
FILE SEARCH
Procedure (CRT/MDI)
Procedure (DPL/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *