Fanuc Power Mate i-D/H Operator Manual

8. DATA INPUT/OUTPUT
B–63174EN/03
OPERATION
396
This section describes how to load a program into the CNC from a floppy
or NC tape.
Inputting a program
1 Make sure the input device is ready for reading.
When using the Power Mate i–D2, select a path for which the program
is to be entered, with the path selection switch or MDI keyboard.
2 Press the EDIT switch on the machine operators panel.
3 When using a floppy, search for the required file according to the
procedure in V–8.2.
4 Press function key
PROG
.
5 Press soft key [(OPRT)]
6 Press the rightmost soft key (next–menu key).
7 After entering address O, specify a program number to be assigned to
the program. When no program number is specified here, the
program number used on the floppy or controller tape is assigned.
8 Press soft keys [READ] and [EXEC]
The program is input and the program number specified in step 7 is
assigned to the program.
1 Select EDIT mode.
2 Make sure the input device is ready for reading.
3 Press
PRGRM
to display the program screen.
4 After entering address O, specify a program number to be assigned to
the program. When no program number is specified here, the program
number used on the floppy or controller tape is assigned.
5 Push the
READ
key.
If a program is input while the data protect key on the machine operators
panel turns ON, the program loaded into the memory is verified against
the contents of the floppy or controller tape.
If a mismatch is found during collation, the collation is terminated with
an alarm (P/S No.79).
If the operation above is performed with the data protection key turns
OFF, collation is not performed, but programs are registered in memory.
8.4
PROGRAM
INPUT/OUTPUT
8.4.1
Inputting a Program
Procedure
Procedure (DPL/MDI)
Explanations
Collation

Leave a Reply

Your email address will not be published. Required fields are marked *