Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
397
When a tape holds multiple programs, the tape is read up to ER (or %).
O1111 M02; ER(%)O2222 M30; O3333 M02;
When a program is entered without specifying a program number.
The O–number of the program on the NC tape is assigned to the
program. If the program has no O–number, the N–number in the first
block is assigned to the program.
When the program has neither an O–number nor N–number, the
previous program number is incremented by one and the result is
assigned to the program.
When the program does not have an O–number but has a five–digit
sequence number at the start of the program, the lower four digits of
the sequence number are used as the program number. If the lower
four digits are zeros, the previously registered program number is
incremented by one and the result is assigned to the program.
When a program is entered with a program number
The O–number on the NC tape is ignored and the specified number is
assigned to the program. When the program is followed by additional
programs, the first additional program is given the program number.
Additional program numbers are calculated by adding one to the last
program.
The method of registration operation in the background is the same as the
method in the foreground. However, this operation registers a program
in the background editing area. As with edit operation, the operations
described below are required at the end to register a program in
foreground program memory.
For CRT/MDI
[(OPRT)][BG–END]
For DPL/MDI
CAN
+
PRGRM
You can input a program to be appended to the end of a registered
program.
Registered program Input program Program after input
O1234 ;
 ;
;
;
;
%
O5678 ;
 ;
 ;
 ;
 ;
%
O1234 ;
 ;
;
;
;
;
O5678 ;
 ;
 ;
 ;
 ;
%
Inputting multiple
programs from a NC tape
Program numbers on a
NC tape
Program registration in
the background
Additional program input

Leave a Reply

Your email address will not be published. Required fields are marked *