Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
399
A program stored in the memory of the CNC unit is output to a floppy or
NC tape.
Outputting a program
1 Make sure the output device is ready for output.
When using the Power Mate i–D2, select a path whose programs are
to be output, with the path selection switch or MDI keyboard.
2 To output to an controller tape, specify the punch code system (ISO or
EIA) using a parameter.
3 Press the EDIT switch on the machine operators panel.
4 Press function key
PROG
, then the program contents display screen or
program check screen appears.
5 Press soft key [(OPRT)].
6 Press the rightmost soft key
(next–menu key).
7 Enter address O.
8 Enter a program number. If –9999 is entered, all programs stored in
memory are output.
To output multiple programs at one time, enter a range as follows :
O∆∆∆∆,O
Programs No.∆∆∆∆ to No. are output.
When bit 4 (SOR) of parameter No.3107 is set to 1 for sorted display
on the program library screen, the programs are output in ascending
order of program numbers.
9 Press soft keys [PUNCH] and [EXEC]
The specified program is output. If steps 7 and 8 are omitted, the
currently selected program is output.
1 Set the output device ready for punch operation.
2 To output to an controller tape, specify the punch code system (ISO or
EIA) using a parameter.
3 Select EDIT mode.
4 Press
PRGRM
to display the program screen.
5 Key in address O.
6 Key in a desired program number.
Entering –9999 causes all programs in memory to be output.
7 The number of input program is punched with pushing
WRITE
.
8.4.2
Outputting a Program
Procedure (CRT/MDI)
Procedure (DPL/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *