Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
401
When a program is punched in ISO code, two CR codes are punched after
an LF code
LF CR CR
By setting bit 3 (NCR) of parameter No.0100, however, only an LF is
output.
Press the
RESET
key to stop punch operation.
All programs are output to paper tape in the following format.
ER
(%)
Program Program Program
ER
(%)
Feed of 1–feet
Feed of 3–feet
The sequence of the programs punched is undefined.
ISO code
Stopping the punch
Punching all programs

Leave a Reply

Your email address will not be published. Required fields are marked *