Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
405
1 Press the EMERGENCY STOP button on the machine side.
2 Set PWE on the setting screen to 1. Alarm PS100 is displayed at this
time.
3 The parameter screen is selected by pressing the
DGNOS/
PARAM
key.
4 Press the
READ
key.
5 NC parameters are input to the memory by this operation.
Normally, P/S alarm 000 is generated after parameters have finished
being read in.
6 Set PWE on the setting parameter to 0.
7 Turn on the NC power again if PS alarm 000 activates.
8 Release the emergency stop button of machine side.
Procedure (DPL/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *