Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
407
To suppress the output of the following parameters, press the [PUNCH]
soft key then [NON–0] soft key.
Other than axis type Axis type
Bit type Parameter for which all bits
are set to 0
Parameter for an axis for
which all bits are set to 0.
Value type Paramter whose value is 0. Parameter for an axis for
which the value is 0.
When the floppy disk directory display function is used, the name of the
output file is PARAMETE.
Once all parameters have been output, the output file is named ALL
PARAMETER. Once only parameters which are set to other than 0 have
been output, the output file is named NON–0. PARAMETER.
Suppressing output of
parameters set to 0
Output file name

Leave a Reply

Your email address will not be published. Required fields are marked *