Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
B–63174EN/03
1. GENERAL
25
Usually, several tools are used for machining one workpiece. The tools
have different tool length. It is very troublesome to change the program
in accordance with the tools.
Therefore, the length of each tool used should be measured in advance.
By setting the difference between the length of the standard tool and the
length of each tool in the CNC (data display and setting : see V–11),
machining can be performed without altering the program even when the
tool is changed. This function is called tool length compensation.
H1
H2
H3 H4
Standard
tool
Workpiece
1.8
TOOL FIGURE AND
TOOL MOTION BY
PROGRAM
Explanations
Machining using the end
of cutter – Tool length
compensation function
(See II–12.1)

Leave a Reply

Your email address will not be published. Required fields are marked *