Fanuc Power Mate i-D/H Operator Manual

8. DATA INPUT/OUTPUT
B–63174EN/03
OPERATION
418
Any program in the memory of the CNC unit can be output to a floppy
as a file.
Outputting programs
1 Press the EDIT switch on the machine operators panel.
2 Press function key
PROG
.
3 Press the rightmost soft key
(next–menu key).
4 Press soft key [FLOPPY].
5 Press soft key [(OPRT)].
6 Press soft key [PUNCH]
.
EDIT * * * * * * * * * *
PUNCH
FILE NO. =
>_
O0002 N01000
(METER) VOL
DIRECTORY (FLOPPY)
NO. FILE NAME
PROGRAM NO. =
11:55:26
0001 PARAMETER
0002 O0001
0003 O0002
0004 O0010
0005 O0040
0006 O0050
0007 O0100
0008 O1000
0009 O9500
58.5
1.9
1.9
1.3
1.3
1.9
1.9
1.9
2.6
[][][][][]F SET O SET STOP CAN EXEC
7 Enter a program number. To write all programs into a single file, enter
–9999 in the program number field. In this case, the file name
[ALL.PROGRAM] is registered.
8 Press soft key
[O SET].
9 Press soft key [EXEC]. The program or programs specified in step 7
are written after the last file on the floppy. To output the program after
deleting files starting with an existing file number, key in the file
number, then press soft key [F SET] followed by soft key [EXEC].
When the procednres 7 and 8 are omitted, the selected program is
output.
10 Press soft key [CAN] to return to the soft key display shown in the
screen of Fig.8.8.1(a).
8.8.3
Outputting Programs
Procedure(CRT/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *