Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
421
To input/output a particular type of data, the corresponding screen is
usually selected. For example, the parameter screen is used for parameter
input from or output to an external input/output unit, while the program
screen is used for program input or output. However, programs,
parameters, offset data, and macro variables can all be input and output
using a single common screen, that is, the ALL IO screen.
READ/PUNCH (PROGRAM) O1234 N12345
MDI
*
* * * * * * * * * * * *
12:34:56
I/O CHANNEL 0 TV CHECK OFF
DEVICE NUM. 3 PUNCH CODE ISO
BAUDRATE 9600 INPUT CODE ASCII
STOP BIT 2 FEED OUTPUT FEED
NULL INPUT (EIA) NO EOB OUTPUT (ISO) CR
TV CHECK (NOTES) ON BAUDRATE CLK. INNER
(0:EIA 1:ISO)>1_
Fig.8.9 ALL IO screen (when channel 0 is being
Fig.8.9 used for input/output)
[][][][][]
PRGRM PARAM OFFSET MACRO (OPRT)
8.9
DATA INPUT/OUTPUT
ON THE ALL IO
SCREEN

Leave a Reply

Your email address will not be published. Required fields are marked *