Fanuc Power Mate i-D/H Operator Manual

8. DATA INPUT/OUTPUT
B–63174EN/03
OPERATION
426
Outputting programs
1 Press soft key [PRGRM] on the ALL IO screen, described in Section
8.9.1.
2 Select EDIT mode. A program directory is displayed.
3 Press soft key [(OPRT)]. The screen and soft keys change as shown
below.
A program directory is displayed only in EDIT mode. In all other
modes, the ALL IO screen is displayed.
O0001 N00010
EDIT
*
* * * * * * * * * * * *
14:46:09
>_
PROGRAM (NUM.) MEMORY (CHAR.)
USED : 60 3321
FREE : 2 429
O0010 O0001 O0003 O0002 O0555 O0999
O0062 O0004 O0005 O1111 O0969 O6666
O0021 O1234 O0588 O0020 O0040
[][][][][]F SRH READ PUNCH DELETE (OPRT)
READ/PUNCH (PROGRAM)
4 Enter address O.
5 Enter a desired program number.
If –9999 is entered, all programs in memory are output.
To output a range of programs, enter O∆∆∆∆, O. The
programs numbered from ∆∆∆∆ to  are output.
When bit 4 (SOR) of parameter No.3107 for sorted display is set to 1
on the program library screen, programs are output in order, starting
from those having the smallest program numbers.
6 Press soft key [PUNCH], then [EXEC].
The specified program or programs are output. If steps 4 and 5 are
omitted, the currently selected program is output.
To cancel output, press soft key [CAN].
To stop output prior to its completion, press soft key [STOP].
Procedure
EXECCANSTOP

Leave a Reply

Your email address will not be published. Required fields are marked *