Fanuc Power Mate i-D/H Operator Manual

8. DATA INPUT/OUTPUT
B–63174EN/03
OPERATION
430
Offset data can be input and output using the ALL IO screen.
Inputting offset data
1 Press soft key [OFFSET] on the ALL IO screen, described in Section
8.9.1.
2 Select EDIT mode.
3 Press soft key [(OPRT)]. The screen and soft keys change as shown
below.
READ/PUNCH (OFFSET) O1234 N12345
MDI
*
* * * * * * * * * * * *
12:34:56
I/O CHANNEL 0 TV CHECK OFF
DEVICE NUM. 3 PUNCH CODE ISO
BAUDRATE 9600 INPUT CODE EIA/ISO
STOP BIT 2 FEED OUTPUT FEED
NULL INPUT (EIA) NO EOB OUTPUT (ISO) CR
TV CHECK (NOTES) ON
(0:EIA 1:ISO)>1_
[][][][][]
READ PUNCH
4 Press soft key [READ], then [EXEC].
The offset data is read, and the “INPUT” indicator blinks at the
lower–right corner of the screen.
Upon the completion of input, the “INPUT” indicator is cleared from
the screen.
To cancel input, press soft key [CAN].
8.9.4
Inputting and
Outputting Offset Data
Procedure
EXECCAN

Leave a Reply

Your email address will not be published. Required fields are marked *