Fanuc Power Mate i-D/H Operator Manual

8. DATA INPUT/OUTPUT
B–63174EN/03
OPERATION
432
Custom macro common variables can be output using the ALL IO screen.
Outputting custom macro common variables
1 Press soft key [MACRO] on the ALL IO screen, described in Section
8.9.1.
2 Select EDIT mode.
3 Press soft key [(OPRT)]. The screen and soft keys change as shown
below.
READ/PUNCH (MACRO) O1234 N12345
MDI
*
* * * * * * * * * * * *
12:34:56
I/O CHANNEL 0 TV CHECK OFF
DEVICE NUM. 3 PUNCH CODE ISO
BAUDRATE 9600 INPUT CODE EIA/ISO
STOP BIT 2 FEED OUTPUT FEED
NULL INPUT (EIA) NO EOB OUTPUT (ISO) CR
TV CHECK (NOTES) ON
(0:EIA 1:ISO)>1_
[][][][][]
PUNCH
4 Press soft key [PUNCH], then [EXEC].
The custom macro common variables are output, and the “OUTPUT”
indicator blinks at the lower–right corner of the screen. Upon the
completion of output, the “OUTPUT” indicator is cleared from the
screen.
To cancel output, press soft key [CAN].
NOTE
To input a macro variable, read the desired custom macro
statement as a program, then execute the program.
8.9.5
Outputting Custom
Macro Common
Variables
Procedure
EXECCAN

Leave a Reply

Your email address will not be published. Required fields are marked *