Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
433
The ALL IO screen supports the display of a directory of floppy files, as
well as the input and output of floppy files.
Displaying a file directory
1 Press the rightmost soft key (next–menu key) on the ALL IO
screen, described in Section 8.9.1.
2 Press soft key [FLOPPY].
3 Select EDIT mode. The floppy screen is displayed.
4 Press soft key [(OPRT)]. The screen and soft keys change as shown
below.
The floppy screen is displayed only in EDIT mode. In all other
modes, the ALL IO screen is displayed.
READ/PUNCH (FLOPPY) O1234 N12345
MDI
*
* * * * * * * * * * * *
12:34:56
>
[][][][][]
F SRH READ PUNCH DELETE RENAME
I/O CHANNEL 0 TV CHECK OFF
DEVICE NUM. 3 PUNCH CODE ISO
BAUDRATE 9600 INPUT CODE EIA/ISO
STOP BIT 2 FEED OUTPUT FEED
NULL INPUT (EIA) NO EOB OUTPUT (ISO) CR
TV CHECK (NOTES) ON
5 Press soft key [F SRH].
6 Enter the number of the desired file, then press soft key [F SET].
7 Press soft key [EXEC]. A directory is displayed, with the specified
file uppermost. Subsequent files in the directory can be displayed by
pressing the page key.
8.9.6
Inputting and
Outputting Floppy
Files
Procedure
EXECCANF SET

Leave a Reply

Your email address will not be published. Required fields are marked *