Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
435
Inputting a file
1 Press the rightmost soft key (next–menu key) on the ALL IO
screen, described in Section 8.9.1.
2 Press soft key [FLOPPY].
3 Select EDIT mode. The floppy screen is displayed.
4 Press soft key [(OPRT)]. The screen and soft keys change as shown
below.
The floppy screen is displayed only in EDIT mode. In all other
modes, the ALL IO screen is displayed.
READ/PUNCH (FLOPPY)
No. FILE NAME
O1234 N12345
(Meter) VOL
EDIT
*
* * * * * * * * * * * *
12:34:56
>
[][][][][]
F SRH READ PUNCH DELETE RENAME
5 Press soft key [READ].
6 Enter the number of a file or program to be input.
Setting a file number: Enter the number of the desired file, then
press soft key [F SET].
Setting a program number: Enter the number of the desired
program, then press soft key [O SET].
7 Press soft key [EXEC].
The specified file or program is read, and the “INPUT” indicator
blinks at the lower–right corner of the screen. Upon the completion of
input, the “INPUT” indicator is cleared from the screen.
Procedure
EXECCANF SET O SET STOP

Leave a Reply

Your email address will not be published. Required fields are marked *