Fanuc Power Mate i-D/H Operator Manual

8. DATA INPUT/OUTPUT
B–63174EN/03
OPERATION
436
Outputting a file
1 Press the rightmost soft key (next–menu key) on the ALL IO
screen, described in Section 8.9.1.
2 Press soft key [FLOPPY].
3 Select EDIT mode. The floppy screen is displayed.
4 Press soft key [(OPRT)]. The screen and soft keys change as shown
below.
The floppy screen is displayed only in EDIT mode. In all other
modes, the ALL IO screen is displayed.
READ/PUNCH (FLOPPY)
No. FILE NAME
O1234 N12345
(Meter) VOL
EDIT
*
* * * * * * * * * * * *
12:34:56
>
[][][][][]
F SRH READ PUNCH DELETE RENAME
5 Press soft key [PUNCH].
6 Enter the number of the program to be output, together with a desired
output file number.
Setting a file number: Enter the number of the desired file, then
press soft key [F SET].
Setting a program number: Enter the number of the desired
program, then press soft key [O SET].
7 Press soft key [EXEC].
The specified program is output, and the “OUTPUT” indicator blinks
at the lower–right corner of the screen. Upon the completion of
output, the “OUTPUT” indicator is cleared from the screen.
If no file number is specified, the program is written at the end of the
currently registered files.
Procedure
EXECCANF SET O SET STOP

Leave a Reply

Your email address will not be published. Required fields are marked *