Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
8. DATA INPUT/OUTPUT
OPERATION
443
Message Description
INSERT MEMORY CARD. No memory card is inserted.
UNUSABLE MEMORY CARD The memory card does not contain device information.
FORMAT MEMORY CARD. The memory card is not formatted. Format the memory card before use.
THE FILE IS UNUSABLE. The format or extension of the file to be loaded is invalid. Alternatively, the
data stored on the memory card does not match the CNC memory size.
REPLACE MEMORY CARD. Replace the memory card.
FILE SYSTEM ERROR  An error occurred during file system processing.  represents a file sys-
tem error code.
SET EMERGENCY STOP STATE. Save operation is enabled in the emergency stop state only.
WRITE–PROTECTED Save operation: The protect switch of the memory card is set to the
disabled position.
VOLTAGE DECREASED. The battery voltage of the memory card has dropped. (The battery requires
replacement.)
DEVICE IS BUSY. Another user is using the memory card. Alternatively, the device cannot be
accessed because automatic operation is in progress.
SRAM MEMORY CARD? This message prompts the user to confirm the start of data saving.
DO YOU WANT TO DELETE FILE(S)? This message prompts the user to confirm the start of deletion.
DO YOU WANT TO PERFORM FORMAT-
TING?
This message prompts the user to confirm the start of formatting.
SAVING Saving is currently being performed.
DELETING File deletion is currently being performed.
FORMATTING Memory card formatting is currently being performed.
COMPLETED Save processing has been completed.
PRESS RESET KEY. Press the RESET key.
TURN OFF POWER. Turn the power off, then back on again.
MEMORY CARD ERROR 1010 The memory card was accessed immediately (within 5 seconds) after it
s inserted into the slot.
The memory card or its format is not supported by the NC.
The memory card is defective.
The end processing after the PC wrote data to files is incomplete.
MEMORY CARD ERROR 99 Part of areas in the memory card is corrupted.
Format the memory card.
Messages and
restrictions
Messages

Leave a Reply

Your email address will not be published. Required fields are marked *