Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
9. EDITING PROGRAMS
OPERATION
463
The cursor can be jumped to the top of a program. This function is called
heading the program pointer. This section describes the three methods for
heading the program pointer.
Heading a Program
1 Press
RESET
when the program screen is selected in EDIT mode.
When the cursor has returned to the start of the program, the contents
of the program are displayed from its start on the screen.
Search for the program number.
1 Press address
O
, when a program screen is selected in the AUTO
or EDIT mode.
2 Input a program number.
3 Press the soft key
[O SRH].
1 Select
[AUTO] or [EDIT] mode.
2 Press
PROG
.
3 Press the
[(OPRT)] key.
4 Press the [REWIND] key.
1 Select AUTO or EDIT mode.
2 Press
PRGRM
key.
3 Press address
O
.
4 Press cursor
.
9.1.2
Heading a Program
Procedure for CRT/MDI
Method 1
Method 2
Method 3
Procedure for DPL/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *