Fanuc Power Mate i-D/H Operator Manual

9. EDITING PROGRAMS
B–63174EN/03
OPERATION
474
When memory holds multiple programs, a program can be searched for.
There are three methods as follows.
Program number search
1 Select EDIT or AUTO mode.
2 Press
PROG
to display the program screen.
3 Key in address
O
.
4 Key in a program number to be searched for.
5 Press the
[O SRH] key.
6 Upon completion of search operation, the program number searched
for is displayed in the upper–right corner of the CRT screen
If the program is not found , P/S alarm No.71 occurs.
1 Select EDIT or AUTO mode.
2 Press
PROG
to display the program screen.
3 Press the
[O SRH] key.
In this case, the next program in the directory is searched for .
This method searches for the program number (0001 to 0255)
corresponding to a signal on the machine tool side to start automatic
operation. Refer to the relevant manual prepared by the machine tool
builder for detailed information on operation.
1 Select
AUTO mode.
2 Set the reset state(*1)
The reset state is the state where the LED for indicating that
automatic operation is in progress is off. (Refer to the relevant
manual of the machine tool builder.)
3 Set the program number selection signal on the machine tool side to a
number from 01 to 255.
If the program corresponding to a signal on the machine tool side is
not registered, P/S alarm (No.59) is raised.
4 Press the cycle start button.
When the signal on the machine tool side represents 00, program
number search operation is not performed.
9.3
PROGRAM NUMBER
SEARCH
Procedure for CRT/MDI
Method 1
Method 2
Method 3

Leave a Reply

Your email address will not be published. Required fields are marked *