Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
9. EDITING PROGRAMS
OPERATION
475
1 Select EDIT or AUTO mode.
2 Press the
PRGRM
key.
3 Key in address
O
.
4 Key in a program No. to be searched.
5 Press cursor
key.
6 When searching is over, the program No. searching is indicated at the
right top of the DPL screen.
1 Select EDIT or AUTO mode.
2 Press the
PRGRM
key.
3 Key in address
O
.
4 Press cursor
key.
NOTE
After displaying all program numbers registered, the display
returns to the first one.
1 Select AUTO mode.
2 Reset the machine.
3 Set the signal for selecting the program No. on the machine side at 01
to 255. (For details, see the instruction manual of the machine tool
builder.)
4 Press the cycle start button.
The program No. (0001 to 0255) corresponding to the signal on the
machine side is searched, and automatic operation starts.
NOTE
1 The program No. is not searched when the signal on the
machine side is ’00’.
2 In the reset condition, the cycle operation lamp is off.
(See the instruction manual of the machine tool builder.)
No. Contents
59 The program with the selected number cannot be searched
during external program number search.
71 The specified program number was not found during program
number search.
Procedure for DPL/MDI
Method 1
Method 2
Method 3
Alarm

Leave a Reply

Your email address will not be published. Required fields are marked *