Fanuc Power Mate i-D/H Operator Manual

9. EDITING PROGRAMS
B–63174EN/03
OPERATION
476
Sequence number search operation is usually used to search for a
sequence number in the middle of a program so that execution can be
started or restarted at the block of the sequence number.
Example) Sequence number 02346 in a program (O0002) is searched
for.
Program
O0001 ;
N01234 X100.0 Z100.0 ;
M12 ;
:
O0002 ;
N02345 X20.0 Y20.0 ;
N02346 X10.0 Y10.0 ;
:
O0003 ;
:
Selected program
Target sequence
number is found.
This section is
searched starting at
the beginning.
(Search operation is
performed only within a
program.)
Sequence Number Search
1 Select AUTO mode.
2 Press
PROG
.
3 If the program contains a sequence number to be searched for,
perform the operations 4 to 7 below.
If the program does not contain a sequence number to be searched
for,select the program number of the program that contains the
sequence number to be searched for.
4 Key in address
N
.
5 Key in a sequence number to be searched for.
6 Press the
[N SRH] key.
7 Upon completion of search operation, the sequence number searched
for is displayed in the upper–right corner of the CRT screen.
If the specified sequence number is not found in the program currently
selected, P/S alarm 60 occurs.
1 Set the mode select switch to AUTO.
2 Press
PRGRM
button.
3 Select the program number to which the sequence number to be
searched for belongs.
Proceed to 4 to 7 when the program contains the sequence number ;
Otherwise, execute Program Number Search to select a program
number to which the sequence number belongs.
4 Key in address
N
.
9.4
SEQUENCE NUMBER
SEARCH
Procedure for CRT/MDI
Procedure for DPL/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *