9. EDITING PROGRAMS
A new program can be created by copying part of a program.
Fig.9.6.2 Copying Part of a Program
In Fig. 9.6.2, part B of the program with program number xxxx is copied
to a newly created program with program number yyyy. The program for
which an editing range is specified remains unchanged after copy
Procedure for Copying Part of a Program
1 Perform steps 1 to 6 in V–9.6.1.
2 Move the cursor to the start of the range to be copied and press soft key
3 Move the cursor to the end of the range to be copied and press soft key
[~CRSR] or [~BTTM] (in the latter case, the range to the end of the
program is copied regardless of the position of the cursor).
4 Enter the number of the new program (with only numeric keys) and
5 Press soft key
of a Program
Procedure for CRT/MDI