Fanuc Power Mate i-D/H Operator Manual

9. EDITING PROGRAMS
B–63174EN/03
OPERATION
488
Unlike ordinary programs, custom macro programs are modified,
inserted, or deleted based on editing units.
Custom macro words can be entered in abbreviated form.
Comments can be entered in a program.
Refer to the V–10.1 for the comments of a program.
When editing a custom macro already entered, the user can move the
cursor to each editing unit that starts with any of the following characters
and symbols:
(a) Address
(b) # located at the start of the left side of a substitution statement
(c) /, (,=, and ;
(d) First character of IF, WHILE, GOTO, END, DO, POPEN, BPRNT,
DPRNT and PCLOS
On the CRT screen, a blank is placed before each of the above characters
and symbols.
(Example) Head positions where the cursor is placed
N
001 X–#100 ;
#1 =123 ;
N002 /2 X[12/#3] ;
N003 X–SQRT[#3/3*[#4+1]] ;
N004 X–#2 Z#1 ;
N005 #5 =1+2–#10 ;
IF[#1NE0] GOTO10 ;
WHILE[#2LE5] DO1 ;
#[200+#2] =#2*10 ;
#2 =#2+1 ;
END1 ;
When a custom macro word is altered or inserted, the first two characters
or more can replace the entire word.
Namely,
WHILE WH GOTO GO XOR XO AND AN
SIN SI ASIN AS COS CO ACOS AC
TAN TA ATAN AT SQRT SQ ABS AB
BCD BC BIN BI FIX FI FUP FU
ROUND RO END EN POPEN PO BPRNTBP
DPRNT DP PCLOSPC
(Example) Keying in
WH [AB [#2 ] LE RO [#3 ] ]
has the same effect as
WHILE [ABS [#2 ] LE ROUND [#3 ] ]
The program is also displayed in this way.
9.7
EDITING OF CUSTOM
MACROS
Explanations
Editing unit
Abbreviations of custom
macro word

Leave a Reply

Your email address will not be published. Required fields are marked *