Fanuc Power Mate i-D/H Operator Manual

9. EDITING PROGRAMS
B–63174EN/03
OPERATION
492
Editing a program while executing another program is called background
editing. The method of editing is the same as for ordinary editing
(foreground editing).
A program edited in the background should be registered in foreground
program memory by performing the following operation:
During background editing, all programs cannot be deleted at once.
Procedure for Background Editing
1 Enter EDIT or AUTO mode.
AUTO mode is allowed even while the program is being executed.
2 Press function key
PROG
.
3 Press soft key
[(OPRT)], then press soft key [BG–EDT].
The background editing screen is displayed (PROGRAM
(BG–EDIT) is displayed at the top left of the screen).
4 Edit a program on the background editing screen in the same way as
for ordinary program editing.
5 After editing is completed, press soft key [(OPRT)], then press soft
key [BG–END]. The edited program is registered in foreground
program memory.
1 Display the background edit screen by pressing the
PRGRM
key while
pressing and holding the
CAN
key.
{ }
2 Specify a program to be edited.
(a) When generating a new program:
O
(program No.)
INSRT
(b) When editing the existing program:
O
(program No.)
3 Program edit
The program editing is the same as with the foreground program
editing operation.
{01000} ;
N10 G92 X0 ;
9.8
BACKGROUND
EDITING
Procedure for CRT/MDI
Procedure (DPL/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *