Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
10. CREATING PROGRAMS
OPERATION
495
Programs can be created in the EDIT mode using the program editing
functions described in V–9.
Procedure for Creating Programs Using the MDI Panel
1 Enter the EDIT mode.
2 Press the
PROG
key.
3 Press address key
O
and enter the program number.
4 Press the
INSERT
key.
5 Create a program using the program editing functions described in
V–9.
1 Select EDIT mode.
2 Press the
PRGRM
key.
3 Key in address
O
.
4 Enter the number of the program to be registered.
5 Press the
INSRT
key.
By pressing this key, the entered program number will be registered.
Enter each word of the program followed by the
INSRT
key to register
it. (See the section on word insertion.)
Comments can be written in a program using the control in/out codes.
Example) O0001 (FANUC POWER Mate) ;
M08 (COOLANT ON) ;
When the
INSERT
key is pressed after the control–out code “(”, comments,
and control–in code “)” have been typed, the typed comments are
registered.
When the
INSERT
key is pressed midway through comments, to enter the
rest of comments later, the data typed before the
INSERT
key is pressed
may not be correctly registered (not entered, modified, or lost) because
the data is subject to an entry check which is performed in normal
editing.
Note the following to enter a comment:
Control–in code “)” cannot be registered by itself.
Comments entered after the
INSERT
key is pressed must not begin with
a number, space, or address O.
10.1
CREATING
PROGRAMS USING
THE MDI PANEL
Procedure for CRT/MDI
Procedure for DPL/MDI
Explanation
Comments in a program

Leave a Reply

Your email address will not be published. Required fields are marked *