Fanuc Power Mate i-D/H Operator Manual

10. CREATING PROGRAMS
B–63174EN/03
OPERATION
498
9 Press
INSERT
. The EOB is registered in memory and sequence numbers
are automatically inserted. For example, if the initial value of N is 10
and the parameter for the increment is set to 2, N12 inserted and
displayed below the line where a new block is specified.
EDIT
* * * *
* * * * * *
PROGRAM O0040 N00012
O0040 ;
N10 G92 X0 Y0 ;
%
_
N12
[][][][][]PRGRM LIB (OPRT)
10 In the example above, if N12 is not necessary in the next block,
pressing the
DELETE
key after N12 is displayed deletes N12.
To insert
N100 in the next block instead of N12, enter N100 and
press
ALTER
after N12 is displayed. N100 is registered and initial
value is changed to 100.
1 Set the setting parameter SEQ to 1.
2 Select EDIT mode.
3 Press
PRGRM
key.
4 Key in address N.
5 Key in the initial value of N, e.g. 10.
6 Press
INSRT
key.
7 Insert each word of the data in one block.
8 Key in
EOB
.
Procedure for DPL/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *